web analytics

100% Pass Ensure 300-365 Dumps with Free VCE and PDF (Question 11 – Question 15)

New 300-365 exam questions from PassLeader 300-365 dumps! Welcome to download the newest PassLeader 300-365 VCE and PDF dumps: http://www.passleader.com/300-365.html (70 Q&As)

P.S. Free 300-365 dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=0B-ob6L_QjGLpR3dFYkJubjFZaDQ

QUESTION 11
What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?

A.    224.0.0.13
B.    224.0.1.39
C.    224.0.0.14
D.    224.0.140

Answer: D

QUESTION 12
An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?

A.    local authentication, local switching
B.    central authentication, central switching
C.    central authentication, local switching
D.    connected mode

Answer: A

QUESTION 13
A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)

A.    All ports participate in the LAG by default when LAG is enabled on the controller.
B.    Dynamic interfaces and management are moved to port 1.
C.    Primary and secondary ports are needed for each interface.
D.    Multiple untagged interfaces to the same port are not allowed.
E.    EtherChannel must be configured for mode “on” on the switch.
F.    Only one functional physical port is needed to continue to pass traffic.
G.    Multiple LAGs are permitted on the controller.
G.    The WLC does not need to be rebooted to enable the LAG configuration.

Answer: ADEF

QUESTION 14
By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?

A.    10 Seconds
B.    60 Seconds
C.    15 Seconds
D.    30 Seconds

Answer: D

QUESTION 15
A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose three.)

A.    verify that Global Multicast mode has been enabled
B.    verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients
C.    make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
D.    verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
E.    change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
F.    verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN

Answer: ABE


New 300-365 exam questions from PassLeader 300-365 dumps! Welcome to download the newest PassLeader 300-365 VCE and PDF dumps: http://www.passleader.com/300-365.html (70 Q&As)

P.S. Free 300-365 dumps are available on Google Drive shared by PassLeader: https://drive.google.com/open?id=0B-ob6L_QjGLpR3dFYkJubjFZaDQ